Mar-Free Drill-Press Fence Alignment
Place a pencil in the drill-press chuck to align the fence without marring the wood's surface.
When I need to drill a series of holes in line along a work surface, I have found that the easiest way to set the distance from the floating fence on my drill press to the drill bit is to put a sharp, straight pencil in the chuck and then mark and measure a board up against the fence as I adjust the distance. A pencil will leave marks that need to be removed, but it won’t mar the surface like a drill bit would.
—Chris Steck, Seattle
Edited and illustrated by Charles Miller.
From Fine Homebuilding #320
RELATED STORIES
Fine Homebuilding Recommended Products
Reliable Crimp Connectors
These reliable, high-quality connectors from Wirefy work on 10-22-gauge wire have heat-shrink insulation to keep out water and road salt.
Handy Heat Gun
This heat gun is great for drying joint compound, primer and paint when patching drywall and plaster walls. Plus it can soften adhesive, get a very cold small engine to start, and shrink heat-shrink tubing.
Affordable IR Camera
This camera is super useful for tracking down air leaks in buildings. The one-hand pistol grip arrangement frees your other hand for steadying yourself while maneuvering tricky job sites.
